Pan through the various service lights until you get to the change oil button. Press the BC button until it says “Reset”. Hold down the BC button a few seconds until it shows the clock which means that you’ve reset the light. The reset mileage and date that that next service is due will show on the screen. BMW’s. service engine light by following these steps: Step 1: Turn on the ignition, but do not start the car. If your BMW has a START button, press it without pressing the brake. Step 2: Hold the small odometer button until a service message appears. Step 3: Press it again until you get a prompt asking for a reset. To turn off the service required light in a Toyota: Turn your car to the “on” position (position two). Be sure to set the odometer to total mileage rather than specific trip mileage. Press and hold the odometer reset button. Turn your car off, then turn back to the “on” position, continuing to hold Turn the car on. Turn the car off. Turn the car on. So, you’re going to be turning the car on, then turning it off and back on three times in a row. You can do this if the indicator is switching on for no reason, or if you’ve just had a tune-up and need to reset your indicator. Another way to reset your check engine light is to do a hard How to reset the Maintenance Required Indicator in 2019, 2020, 2021, 2022, and 2023 Toyota RAV4 using the multi-information display.Toyota RAV4 (2019-2024): Step 1: Turn the car to the "run" position and make sure the odometer is showing (some Toyota's need to be on "Trip A" Step 2: Hold down the "reset trip" button and shut the car off. Step 3: Keep TXmfgI. STEP 4. Then Hold Odo/Trip Reset Button, Then Press The “ ENGINE START STOP BUTTON ” Twice or Turn Ignition ON only, Don’t Release The Odo/Trip Button, Until The RESETTING OIL MAINTENANCE DATA or “ 000000 ” is displayed. Depress and HOLD the Trip Meter RESET button while turning the ignition switch to the ON position. 5. The Service Maintenance Reminder Light will. Illuminate solidly for 3 seconds. Blink for 2 seconds. Illuminate solidly for 1-second. Turn off. 6. Release the Trip Meter RESET button. This video shows u how to reset the "Maint Req'd" light after doing an oil change on a 2010 Toyota Corolla. The next step is to get into the Maintenance. Select OIL CHANGE. At this point, you can see some maintenance options. So we want pull-downs to go to Oil Change and it will show that you have some miles before the next before the oil changes. Select RESET. From there you can change the settings or you can go to the bottom and reset it. Confirm it Switch the ignition over to the on position. Then you’re gonna press the Menu button on the steering and go to that little gear ⚙️ it’s called USER SETTINGS. Next, you go down to SERVICE INTERVAL and select that by pushing OK. After that, you’re gonna go down to ADJUST INTERVAL and you just click on it.

how do you reset the maintenance light